Las Cruces Premium Roofing provides professional metal roofing & pan restoration in Las Cruces, NM for residential and commercial properties across the Mesilla Valley. Metal means two entirely different jobs in this county. On a site-built house it is a covering you choose and pay for. On a manufactured home it is usually the roof that already came from the factory, and the right work is restoring it rather than replacing it.
Start with the second case, because it is the larger one here. A HUD-code home's original roof is typically a thin metal pan seamed at the ends and fastened at a perimeter rail, and it is far more durable than its reputation. What fails is the sealant at the seams, the fastening at the eave rail, and every hole somebody cut into it later for an antenna, a cooler, or a vent.
On those roofs a full replacement is often the wrong purchase. Cleaning the pan, re-seaming with reinforcing fabric, addressing the rail, and coating the whole assembly delivers a warranted, watertight roof for a fraction of a tear-off, and it leaves the original structural sheet doing the job it was engineered to do. We will quote a replacement if the pan is perforated or the deck below is soft, and not otherwise.
On site-built homes the choice is between standing seam and exposed-fastener panel, and the honest answer in the Mesilla Valley depends on how long you plan to own the house. Standing seam hides its fasteners under the seam and can run forty years with almost no attention. Screw-down panel costs substantially less up front and needs its fasteners revisited on a schedule.
That schedule is the part nobody mentions at the sale. In this heat a 29-gauge panel expands and contracts against a fixed screw every single day, the neoprene washer flattens, and somewhere around year twelve you are buying a re-screw. Budget for it and screw-down metal is a genuinely good value. Ignore it and you will decide metal roofs leak.
Detailing is where metal is won or lost. Panels get set over purlins or a solid deck with a slip sheet, closures go in at eave and ridge rather than a bead of caulk, and every penetration gets a formed boot rather than a field-cut hole. Metal does not forgive improvisation the way asphalt does, because a panel moves every day and drags whatever you attached to it along.
Our licensed and insured team brings the right materials and equipment to every job — HUD-code roof pans re-seamed with embedded reinforcing fabric, silicone restoration membrane applied at 22 to 26 dry mils, roof-mounted evaporative cooler curbs with base and counter flashing, 29-gauge exposed-fastener panel refastened to oversize diameter screws, tapered polyisocyanurate cut to a quarter inch per foot with crickets, two-ply granulated modified bitumen over a low-slope valley-floor deck — and backs the work with a written workmanship warranty. We serve Las Cruces and nearby communities including Sunland Park, Chaparral, Anthony, Santa Teresa.
What We Handle
Everything our metal roofing & pan restoration in Las Cruces covers
One crew, one point of contact, and the full range of metal roofing & pan restoration work in Las Cruces, NM. If it is on this list we do it in house rather than handing it to a subcontractor:
- metal roofing Las Cruces
- standing seam roof NM
- exposed fastener metal panel
- screw down metal roof
- mobile home metal roof repair
- metal roof re-screw
- 29 gauge metal roofing
- metal roof coating restoration
- metal roof cost Las Cruces
- metal roof over purlins
- manufactured home roof pan
- metal roof closures ridge
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Las Cruces services.
Materials, equipment and how we do metal roofing & pan restoration
The difference between metal roofing & pan restoration that lasts and metal roofing & pan restoration that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with HUD-code roof pans re-seamed with embedded reinforcing fabric, silicone restoration membrane applied at 22 to 26 dry mils, roof-mounted evaporative cooler curbs with base and counter flashing, 29-gauge exposed-fastener panel refastened to oversize diameter screws, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Las Cruces job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in the Mesilla Valley means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do metal roofing & pan restoration outside Las Cruces
Las Cruces Premium Roofing covers Las Cruces and the surrounding communities of the Mesilla Valley. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Metal Roofing & Pan Restoration in Sunland Park, NM — Dona Ana County, population 16,702
- Metal Roofing & Pan Restoration in Chaparral, NM — Dona Ana County, population 16,551
- Metal Roofing & Pan Restoration in Anthony, NM — Dona Ana County, population 8,693
- Metal Roofing & Pan Restoration in Santa Teresa, NM — Dona Ana County, population 5,044
- Metal Roofing & Pan Restoration in University Park, NM — Dona Ana County, population 3,007
- Metal Roofing & Pan Restoration in Vado, NM — Dona Ana County, population 2,930
Start on the Las Cruces Premium Roofing homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Las Cruces Chooses Las Cruces Premium Roofing
- ✓We settle the recover question with a core cut before quoting, so you learn whether New Mexico's rewritten reroofing rule permits a second layer on your roof or forces a full tear-off.
- ✓We price manufactured home roofs as restoration work first, because a sound factory metal pan cleaned, re-seamed and coated is a warranted roof at a small fraction of a replacement.
- ✓We say where our license stops. Structural work on a HUD-code home answers to the Manufactured Housing Division, and framing changes answer to a framing or general building classification, not to a roofing license.
- ✓We diagnose leaks by controlled water testing rather than waiting for weather, because a roof here gets tested on roughly 24.5 days a year and a defect can hide for a season.
The standards behind metal roofing & pan restoration
Quality here is not a matter of opinion — it is written down. The metal roofing & pan restoration work we do in Las Cruces follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every metal roofing & pan restoration project in Las Cruces gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free metal roofing & pan restoration free estimate in Las Cruces, or request a quote and we'll get right back to you.